Almost all the parts are here!

[Adam90xj]

hey adam check your inbox on floridajeepers. Maybe we can use your new setup on some stuff for my heep

Will do. The electronics are still atleast a week or 2 away. They assemble the kit, test it, calibrate the THC module, and then ship it.

Later,
Adam

[91Toyota4x4]

If that goes missing it wasn't me

[Robert87xj]

I was wondering what that was when i came over there the other day. Good luck making room for it in your shop!

[Adam90xj]

If that goes missing it wasn't me

[Adam90xj]

I was wondering what that was when i came over there the other day. Good luck making room for it in your shop!

Hey! no peeking!

[Adam90xj]

All the parts should be here Thursday

To bad I've been so darn busy I haven't mounted the rack/pinion, and hardened v rails

might have to take off Thursday and Friday

[Adam90xj]

The table is alive!




I'm actually further along than this, as I've actually used the manual mode to cut some stuff but not in the full program mode because my DTHC isn't working right yet.

BUT

[Lil Ugly]

I could definitely make use of a cnc table. I am doing pretty good free hand, and the drag shields do well for some things. not as good as a table will be for sure.

[Adam90xj]

:pray: I could definitely make use of a cnc table. I am doing pretty good free hand, and the drag shields do well for some things. not as good as a table will be for sure.

I know what you mean. I was using a cheap china ParkerMP with HF start. That thing pissed me off to no end. This HT Powermax 45 is sweet.

The machine cut on it's own lastnight!!! I think there's a problem with the Postprocessor output from the cam software I'm using to generate the G-code. The THC is almost fully functional and pierces and maintains voltage well.

Needless to say no pictures until it's right!

[4PlayXJ]

So.... What is the ultimate goal for this machine?

Gonna build any custom firearms?